Antenna System 2.0 (#AS-2)

 

Q: How do I power the #AS-2?

A: The #AS-2 accepts AC or DC power (5V- 12V), 100mA Max. This circuit is designed to operate under any straight DC or AC current provided the voltage doesn’t exceed 12v, 100mA. If you are using a DC power pack transformer we strongly recommend using the fixed AC output terminals.

____________________________________________________________________________________________________________________________

 


Q: How many Antennas can I power at once?

A: The #AS-2 can power up to Two (2) Antennas at once.

____________________________________________________________________________________________________________________________

 

Q: Do I need to use Resistors?

A: Yes, Connect the Provided Resistors to the Common or "C" terminals.

____________________________________________________________________________________________________________________________

 

Q: How do I get the obstruction lights working?

A: Obstruction features can be put to work by soldering the wire leads to the round pads labeled "V+" and "GND". Make sure to use a 1k resistor when activating this feature.

____________________________________________________________________________________________________________________________

 

Q: How Many Obstruction Lights Can I connect?

A: The #AS-2 can handle Two (2) LED's as Obstruction Lights at the same time.

____________________________________________________________________________________________________________________________

 

Q: Can I break or disconnect the Jumper wire?

A: No.

____________________________________________________________________________________________________________________________

 

Q: Can the Circuit Operate without the Jumper wire?

A: No.